Dascom TallyCom III Installation & Operators Guide Instrukcja Użytkownika Pobierz pdf (Strona 34)

The SCS VCS command is supported.

Characters below 40 HEX not matching the valid SCS code table

below are passed directly to the printer, i.e. these characters should

have ASCII HEX values.

Characters in SCS TRN commands: Printable characters (Chars >

39 HEX) are treated as characters outside SCS TRN commands.

Characters below 40 HEX including those matching the valid SCS

code table below are treated as LU3 characters, i.e. these characters

are directly translated to ASCII HEX values by the use of the actual

translate table.

4 Emulating another Printserver

The SCS VCS command is supported.

Characters below 40 HEX not matching the valid SCS code table

below are printed as spaces.

Characters in SCS TRN commands: All characters are passed

directly to the printer, i.e. these characters should have ASCII HEX

values.

8 Emulating another Printserver

The SCS VCS command is supported.

Characters below 40 HEX not matching the valid SCS code table

below are suppressed.

Characters in SCS TRN commands: Printable characters (chars > 39

HEX) are treated as characters outside SCS TRN commands.

Characters below 40 HEX including those matching the valid SCS

code table below are printed as spaces.

EFFECT: Immediate.

RELATED: None.

NOTES:

1. This function only has effect on LU1 SCS datastream.

2. Where the SCS VCS command is not supported, one line feed is sent to the printer if an SCS

VCS command is received. Where the SCS VCS command is supported, as many line feeds

as required by the SCS VCS command are sent to the printer if an SCS VCS command is

received.

3. If an SCS SVF command is received outside page boundary, the page will not be ejected, but

the following line will be regarded as top of form on a page with the new form length.

4. Unprintable characters are LU1 HEX 00-3F with the exception of the SCS codes listed below:

Code Name HEX

ESC SCS ESC character

(SHF, SVF, SLD, SPD, PPM)

HT Horizontal Tab 05

VT Vertical Tab 0B

VCS Vertical Channel Select 04

LF Line Feed 25

FF Form Feed 0C

IRS Interrecord Separator 1E

NL New Line 15

CR Carriage Return 0D

BS Back Space 16

TRN Transparent 35

BEL Bell 2F

ENP Enable Print 14

INP Inhibit Print 24

GE Graphic Escape 08

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 59 60

Komentarze do niniejszej Instrukcji

ok 11 Feb 2024 | 07:50:22

yes

Dascom TallyCom III Installation & Operators Guide Instrukcja Użytkownika Strona 34

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Drukarki Dascom TallyCom III Installation & Operators Guide