Dascom TallyCom III Installation & Operators Guide Instrukcja Użytkownika Pobierz pdf (Strona 14)

2. If the permanent memory area is unreadable, the permanent memory area will be reset, the

factory defaults read and an error message will be printed, indicating the action taken (see the

appendix on Error Messages). Operation starts using factory default settings.

3. The interface checks the rest of the printer (self-test). If the printer is malfunctioning, the

Printserver interface will, if possible, indicate error.

4.7.3 Storing and Restoring Settings

The following commands permit you to read and save in the permanent memory area under program

control. You may also read the factory defaults under program control. Overleaf is shown these

commands ("%" is the defined escape character).

%X1 Save setup in permanent memory area (FLASH)

%X3 Read and activate default setup

%X4 Read and activate permanent memory setup (FLASH)

Commands for storing and restoring settings

Note: Please observe that when one of the above commands are used, the temporary escape

character, if any, will be removed.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 59 60

ok 11 Feb 2024 | 07:50:22

yes

Dascom TallyCom III Installation & Operators Guide Instrukcja Użytkownika Strona 14