Dascom 7010 Peeler Installation and User Guide Instrukcja Użytkownika Pobierz pdf

Installation Guide 7010 Peeler Unit

This guide is provided for use by service representatives who must install the

peeler unit. If the peeler is not installed, please contact your supplier.

(1) Check to make sure that the printer's power switch is turned off then disconnect the

power cord.

(2) Open the top cover and lift the thermal printhead and sensor arm.

(3) Remove the operation panel on

the front of the printer (2 screws).

When doing this, remove the

flexible cable that is connected

to the operation panel.

(4) Remove the front right cover on

the front of the printer. (2 screws)

Head open lever

Sensor arm open lever

Thermal printhead

Flexible cable

Sensor arm

Top cover

Operation

panel

Front right

cover

Note Installation requires a cross-point ('Phillips') screwdriver with magnetic tip and a

shaft at least 200 mm (8 inches) long.

Caution

1 2 3 4

(2 screws) 2

Podsumowanie treści

Strona 1

Installation Guide 7010 Peeler UnitThis guide is provided for use by service representatives who must install the peeler unit. If the peeler is not in

Strona 2 - (2 screws)

(6) Remove the plastic cover from the front center cover that you have removed. (2 screws)Note The plastic cover that you have removed is needed if

Strona 3

Release knobPeeler unitAlignment holes and pins(8) Attach the connector of the peeler unit to the daughter board as shown in the figure.Note The conn

Strona 4

Komentarze do niniejszej Instrukcji

Brak uwag

Dascom 7010 Peeler Installation and User Guide Instrukcja Użytkownika

Przeglądaj online lub pobierz Instrukcja Użytkownika dla Drukarki Dascom 7010 Peeler Installation and User Guide. Dascom 7010 Peeler Installation and User Guide User Manual Instrukcja obsługi

Podsumowanie treści

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Drukarki Dascom 7010 Peeler Installation and User Guide